Since the March article on ‘Electric Vehicle (EV) Charging Accessibility Issues’, we have continued working on the development of guidance to address some of the issues identified, particularly around the spatial requirements for the use of EV charging bays. This current project for Electric Vehicle Standards Development is being supported by Durham County Council, and the ‘Scaling on Street Charge-point Installations’ (SOSCI) Project funded by the Office for Zero Emission Vehicles (OZEV).
Our Electric Vehicle Charge-point (EVCP) Development Project involves several stages for the development of guidance for the design and installation of accessible electric vehicle charging equipment and charging bays, to inform and guide installers, equipment designers, and manufacturers: on the basis of an inclusive design approach.
A further stage within this project will be the development of planning guidance for site location suitability where charge-points cannot be located on-street. This will identify the considerations required for EV charging facility locations, to be accessible for pedestrian approach and access and responsive to local neighbourhood requirements where dwellings do not have off-road parking.
We are currently consulting on our initial guidance, accompanied by example charging bay layouts, based on current BS 8300 guidance. This new draft design guidance for EV charging bays provides 1600mm access aisles between vehicles parked at 90-degrees to a kerb-line or footpath, and similar width clearance at the head of bays, to accommodate manoeuvring around and between vehicles for connection of the charging cable and access to the charge-point. Example layouts have also been prepared for parking parallel to the kerb-line.


The diagrams pictured show examples of these layouts. Diagram 5 demonstrates the potential location of the charge-point at the vehicle bay level for ease of access and reach. The diagram also aims to demonstrate the limitations of accessibility for drivers who require space to manoeuvre around their vehicle for charging, where the standard depth of 3.6m does not easily accommodate such activity without positioning the vehicle close to the kerb, and the driver’s movements being at risk from passing vehicles. In practice, this potentially means a depth of bay greater than 3.6m requires consideration, where this can be achieved, or alternatively level access between the bay and the pedestrian route.
It may also be worth noting that, the current minimum depth of bays at kerbside on the highway for vehicles is 1.8m with no maximum depth or length as noted in the Department of Transport Circular 01-2016 for The Traffic Signs Regulations and General Direction 2016. The intention of this change has been ‘to allow traffic authorities flexibility in determining the bay or parking space size appropriate for the intended vehicle type and the surrounding street environment’. However, the minimum depth of bays at kerbside for Blue Badge Holders is still prescribed as 2.7m; in light of advice from the Disabled Persons Transport Advisory Committee.
It should be noted that, once the cable connection between the vehicle and the charge-point is completed, cables should not remain spread about as shown only for diagrammatic purpose in image 5 to indicate the potential cable routes; and instead cables should be pulled in close to the vehicle and/or kerb before leaving the vehicle, to minimise any obstruction or trip hazard.
If anyone has any experiences to share in relation to the use and charging of plug-in vehicles, or questions in relation these current proposals for accessibility at EV charging bays, or would like to be involved in consultation on this guidance development, please get in touch with Steve at accessconsultant@btinternet.com or James Taylor at james@accessidc.com.






